PumpFun Copytrade
How to create tasks for Raydium Copytrade
1. Create Task & General Settings
Go to the 'Defi' tab
Press Create Tasks
Choose a task name
Select Raydium Copy Trade
Select the wallets to use
2. General DeFi Settings
Enter & Select all the general task settings
A detailed guide can be found here
3. Extended Sell Settings
Trailing Stop
A stop loss % that is adjusted according to your take profit positions
Stop Loss
The stop loss as a %
Sell If Dev Sells
Close position if dev sells X% of their holding
Sell Bonding Curve Progress
Sell part of your position when there is X% growth
Sell Bonding Curve Position
How much of your position to sell on X% growth
Inactivity Timeout
Close position if there are no trades in seconds
Profit Timeout Position
How much of the position to sell if the following values are not met
A. Profit Timeout %
How much profit % to be achieved in the timeframe
B. Profit Timeout Delay
The amount of time the profit must be achieved in (in s)
Sell On Migration
How much (%) of your position to sell on migration
4. Copytrade Settings
Traders Addresses
The address to copy trade
You can enter multiple by separating them with a comma
Min & Max Trader Buy
The range of SOL the trader can use to purchase a token
Min & Max Buy Amount
The range of your trades when using CT buy %
You will not enter a trade with values outside of this range
CT Buy Percentage
What % of the CT buy to trade at
e.g. If the trader spends 10 SOL, and you use 20% you will enter with 2 SOL
Token Repurchase
Lunar will repurchase the same token if the trader purchases again
Trader Unique Purchase
Purchase a token when a trader buys it for their first time
Sell With Trader
Sell the same % of your position as the trader
Last updated
